The way to Disassemble an Xbox 360 system Wireless Controller

The xbox 360 controller is usually disassembled to get ready for modifications. Some popular modifications included replacing the directional pad or replacing the exterior cover. Any remaining warranty likely is going to be voided by disassembling your XBox 360's wireless controller. Bear this in mind before starting taking it apart. A small-Torx screwdriver is needed. You could be capable of get one from your hardware or electronics store; otherwise, they come online.



Instructions

1. Power the controller off. Transform it over and depress the tab on the power supply to eliminate it from your controller. Take it to a table or workstation for disassembly.

2. Take away the six screws from your perimeter with the XBox 360 controller when using the T8 screwdriver, then get rid of the single screw in the battery compartment.

3. Lift the spine compartment journey Xbox 360 console controller. This provides access to the card as well as the vibration motors.

4. Pull off the most notable and bottom panels. The top panel is designed for the shoulder buttons. The lower panel bridges the 2 halves from the xbox 360 controllers.

5. Carefully lift the circuit card out from the case. The screws you removed earlier also mounted the board, so absolutely nothing is left to secure it.

6. Get rid of the rubber directional pads from inside the main front case. Pull them up gently to clear out them. Behind the standard directional pad, you'll find two more screws. Take them of with the T8 screwdriver to eliminate the directional pad.

7. Take away the shoulder buttons from your circuit board if desired. Dependant upon what you are doing, this may not be necessary. To remove the shoulder buttons, push them down gently, then pull them away from your spring attaching these phones the circuit card.

How you can Mod Your Xbox 360 elite Controller ( http://www.vdealbox.com/xbox-360-accessories/xbox-360-controller.html ) for 'Tiger Woods'

Unlike most games, which allow one to modify the configuration of your respective controller's buttons through the options sub-menu within the game's main menu, you will need to make any controller adjustments to-game for the "Steve stricker PGA Tour" combination of games for that Xbox 360 system. Once you begin your game, you can change the actions your xbox 360 wireless controller buttons perform to fit your preferences and increase your gaming experience.

Instructions

1. Start the overall game and allow the golf match to load before you can pause the game. In the event the match has loaded, press "Start" to pause the sport.

2. Scroll down with the pause menu and soon you reach "Options," then press "A."

3. Scroll down and soon you reach the "Controls" option, then press "A." Follow the onscreen prompts to vary the button configuration for your preferences.