Repair a Nintendo DS Lite

The Nintendo DS Lite is extremely popular among young kids. The hinge keep upper screen to the main body with the Lite features a defect that can make it warp and crack. Repairing the hinge requires replacing the whole top shell in the Ds by nintendo which holds the secondary touchscreen technology. Doing the replacement yourself requires a bit of patience however it helps you to save a lot of cash and let you return to doing offers faster than sending it to a repair center.



Instructions

1. Position the clean cloth recorded on a work surface. Put the Nintendo ds upon the clean cloth face-down.

Take away the eight screws within the back using the NDS screwdriver. Put the screws aside.

2. Turn the ds lite repair parts and hang it documented on the clean cloth.

Carefully pull the shell up and from the underlying part from the Nintendo ds lite. Ensure that you leave both the shoulder button shafts and springs each and every side alone so they really remain in position on the bottom of the case.

3. Unplug the small white cable by lifting the connector served by a fingernail. Unplug the little black wire by pulling it off its connector. Pull the little white cable as well as the black wire out of your top casing over the hinge.

4. Unplug each display cables by lifting the limited black tumble each by using a fingernail on either side.

Remove the small screw at the bottom keep motherboard towards the case using the jeweler's screwdriver. Place the screw aside.

5. Lift the motherboard up and out of the bottom from the case. Place the motherboard aside carefully.

6. Pry a few regions of underneath assembly apart together with your fingernail. Lay the display part aside and cover it with the touchscreen display screen part and then with all the protective shield part on top.

7. Get rid of the screw covers on the top screen using the jeweler's screwdriver. Eliminate the four screws which might be now revealed. Place the screws as well as the screw covers aside.

8. Get rid of the two screws in the upper left corner from the top screen while using jeweler's screwdriver. Squeeze screws aside.

Take away the top screen casing with the hinge and carefully desolder the speaker ribbon cable wires from the top display. Eliminate the top casing and put it away or dump it.

9. Go ahead and take three areas of the display and reassemble them throughout the top casing with the hinge.

Consider the replacement top casing with hinge and it into position from the bottom casing.

10. Run the white wire as well as the black wire from the top casing with the hinge and fix each of the wires thus to their original position. Attach both the display wires with their original position.

11. Turnaround for the disassembly process to set the Ds lite Lite together again again. jklzaeqc 1031